McKetta, J. J. and W. A. Cunningham (1992). Encyclopedia of chemical processing and design Vol 41: polymers, rubber modified to pressure-relieving devices, rapture disks, low burst pressures. New York, Marcel Dekker.
|
McKetta, J. J. and W. A. Cunningham (1992). Encyclopedia of chemical processing and design. Vol.40. Polymers, polyamides, aromatic to polymers, polyvinylchloride. New York, Marcel Dekker.
|
McKetta, J. J. and W. A. Cunningham (1992). Encyclopedia of chemical processing and design: eexecutive editor John J. McKetta, associate editor William A. Cunningham. New York, Dekker.
|
McLean, M. R. (1988). Analysis of wellbore stability.
|
McLoughlin, J. C. (1992). The characterisation and fracture of oriented glassy polymers, Leeds.
|
McLoughlin, S. D. (2004). The characterisation of archaeological glasses using advanced analysis techniques: 254 leaves.
|
McMaster, R. C. (1982). Nondestructive testing handbook. [Columbus, Ohio], American Society for Nondestructive Testing.
|
McMillan, F. M. (1979). The chain straighteners: fruitful innovation, the discovery of linear and stereoregular synthetic polymers. London; New York, Macmillan Press.
|
McNally John, A. (1996). Studies on blends of polymers with bitumen, Queen's University of Belfast.
|
McNaughton, K. J. (1980). Materials engineering. New York, Chemical Engineering.
|
McNeill, I. C. (1971). Studies of the structure and stability of high polymers.
|
McNicol, A. (1994). The influence of electrical potential and transfer film formation upon the friction and wear of polymers, Leeds.
|
McQuillan, F. C. (1993). The response of Silceram glass-ceramics to projectile impact.
|
McRitchie, T. D. (1969). Reactions of anionic polymers.
|
McShea, J. and D. Byrne (1981). Materials technology. Pupil's book, Teacher's guide + Workbooks. G.B., Oliver & Boyd/National Centre for School Technology.
|
Mead William, T. (1974). Molecular fracture in mechanically deformed polymers, University of London.
|
Mead, W. T. (1975). Molecular fracture in mechanically deformed polymers.
|
Meadow Jacob, R. (1934). Ring Compounds and Polymers from Polymethylene Dihalides and Dimercaptans. A dissertation, [Baltimore].
|
Meadow, J. R. (1934). Ring compounds and polymers from polymethylene dihalides and dimercaptans. [Easton, Pa.
|
Meares, P. (1965). Polymers. Structure and bulk properties. [With plates.]. London, D. Van Nostrand Co.
|
Meares, P. (1965). Polymers: structure and bulk properties. London, New York, Van Nostrand.
|
Mebane, R. C., T. R. Rybolt, et al. (1995). Plastics & polymers. New York, Twenty-First Century Books.
|
Meenakarn, C. (1999). A TEM investigation of atomic ordering in AIGainP epilayers grown on GaAs(001) by gas-source MBE.
|
Meeten, G. H. (1986). Optical properties of polymers. London; New York, Elsevier Applied Science Publishers.
|
Meghea, A., I. Rau, et al. (2004). Proceedings of the 7th international conference on frontiers of polymers and advanced materials: ICFPAM. Philadelphia. Pa., Taylor & Francis.
|
Megson Joanna, L. and D. University of (1997). The synthesis and characterisation of water soluble polymers and biomimetic applications.
|
Megson Norman Joseph, L. (1947). Plastics. A short account of developments, applications and potentialities of synthetic high polymers. [With plates.]. London, Published for the British Council by Longmans, Green & Co.
|
Megson, N. J. L. (1947). Plastics, a short account of developments, applications and potentialities of synthetic high polymers. London, New York, Pub. for the British Council by Longmans Green.
|
Megson, N. J. L. (1947). Plastics: a short account of developments, applications an potentialities of synthetic high polymers.
|
Megson, T. H. G. (1980). Strength of materials for civil engineers. Walton-on-Thames, Surrey, Nelson.
|
Megson, T. H. G. (1987). Strength of materials for civil engineers. London, Edward Arnold.
|
Meguid Shaker, A., Ed. (2000). Mechanics and mechanisms of failure of interfaces in engineering materials, Elsevier.
|
Mehmet-Alkan, A. A. (1994). Studies on aromatic polymers. Birmingham, University of Birmingham.
|
Mehryar, H. (1978). The effect of pulsing on the injection of drag reducing polymers.
|
Meijer, H. E. H. (1997). Processing of polymers. Weinheim; Chichester, Wiley-VCH.
|
Melanitis, N. (1991). An investigation of the tensile, compressive and interfacial properties of carbon fibres, using laser Raman spectroscopy.
|
Melia, T. P. (1961). Entropies of polymerisation by determination of specific heat of high polymers in the temperature range 20-300 K, Leeds.
|
Mellon, M. G. (1988). Market assessment of the uses of advanced composite materials in the aerospace industry.
|
Meltzer Yale, L. (1981). Water Soluble Polymers developments since 1978, Noyes Data Corporation.
|
Meltzer Yale, L. and C. Noyes Data (1981). Water-soluble polymers: developments since 1978. Park Ridge, N.J., Noyes Data Corporation.
|
