Masters John, E., J. Au Joseph, et al. (1987). Fractography of modern engineering materials: composites and metals: Symposium: Papers. Philadelphia, PA, ASTM.
|
Masters, H. J. M. and S. University of (2003). Hyperbranched polymers and their silica hybrids as epoxy resin modifiers. Guildford, University of Surrey.
|
Masters, J. E. (1992). Damage detection in composite materials. Philadelphia, PA, ASTM.
|
Masters, J. E. and M. International Symposium on Damage Detection and Quality Assurance in Composite (1992). Damage detection in composite materials. Philadelphia, PA, ASTM.
|
Masubuchi, K. and E. Massachusetts Institute of Technology. Dept. of Naval Architecture and Marine (1970). Materials for ocean engineering. Cambridge [Mass.]; London, M.I.T. Press.
|
Matemilola Saka, A. (1993). Impact damage to composite materials, University of Cambridge.
|
Materials and Design Against, F., G. Institution of Mechanical Engineers. Materials, et al. (1992). Materials and design against fire: international conference, 27-28 October 1992, Institution of Mechanical Engineers, Birdcage Walk, London. [London], Mechanical Engineering Publications for IMechE.
|
Materials Engineering Research Laboratory, L., M. C. S. International, et al. (1999). Evaluation of polymers for high temperature flexible pipe: final reports. Bootle, Health & Safety Executive.
|
Materials Handling, E. (1998). Going with the flow: the 1998 roundtable report, Penton Media.
|
Materials Information (Information service), ASM International., et al. (1988). Thesaurus of engineered materials: a vocabulary listing for use in indexing, storage, and retrieval of technical information on polymers, ceramics, and composite materials. Metals Park, Ohio
|
Materials Research, C. (1987). The book of basics. [Orangeburg, New York], Materials Research Corporation.
|
Materials Science and Engineering Laboratory (U.S.). Polymers Division., E. J. Amis, et al. (2001). Materials science and engineering laboratory: FY 2001 programs and accomplishments: Polymers Division. [Gaithersburg, Md.?], U. S. Department of Commerce, Technology Administration, National Institute of Standards and Technology.
|
Materials Science, S. and D. American Society for Metals. Materials Science (1979). Fatigue and microstructure: papers presented at the 1978 ASM Materials Science Seminar, 14-15, October, 1978, St. Louis, Missouri. Metals Park, Ohio, The Society.
|
Materials Technology Institute of the Chemical Process Industries (U.S.) and Verity Consulting Group. (1993). Benchmarking materials engineering: final report. Los Angeles, CA (12021 Wilshire Blvd., Suite 825, Los Angeles 90025), Verity Consulting Group.
|
Materials, I. (1993). Polymers / ceramics / composites alert. Materials Park, Ohio, Materials Information.
|
Materials, I. (1996). Advanced polymers abstracts. Materials Park, Ohio; London, Materials Information.
|
Materials, I., A. S. M. International, et al. (1987). Thesaurus of engineered materials: a vacabulary of listing for use in indexing, storage and retrieval of technical information on polymers, ceramics and composite materials. Metals Park; London, ASM International: Institute of Metals.
|
Materials, I., M. American Society for, et al. (1990). Thesaurus of engineered materials: the vocabulary that controls storage and retrieval of technical information on polymers, ceramics and composite materials. Metals Park; London, ASM International: Institute of Metals.
|
Mathias Lon, J. and A. C. S. D. o. P. Chemistry (1991). Solid state NMR of polymers: Symposium: 3rd Annual chemistry conference of North America: Papers, Plenum Press.
|
Mathias, L. J. (1991). Solid state NMR of polymers. New York, Plenum Press.
|
Mathot Vincent, B. F., Ed. (1993). Calorimetry and thermal analysis on polymers: Course: Revised papers, Hanser.
|
Mathur, G. N., L. D. Kandpal, et al., Eds. (2000). Proceedings of recent advances in polymers and composites.
|
Mathur, N. K., C. K. Narang, et al. (1979). Polymers as aids in organic chemistry. New York, Academic Press.
|
Mathur, N. K., C. K. Narang, et al. (1980). Polymers as aids in organic chemistry. New York.a London [etc.], Academic Press.
|
Matthews Siobhan, O. (1999). Development of preceramic polymers for high temperature composite applications, Brunel University.
|
Matthews Susan, E. (1995). Synthesis of biodegradable polymers for delivery of diagnostic agents, University of Bath.
|
Matthews, F. L. (1990). The failure of reinforced plastics: papers reprinted from a special issue of the Journal of strain analysis for engineering design, vol.24, no.4, October 1989. London, Mechanical Engineering Publications.
|
Matthews, F. L. and R. D. Rawlings (1994). Composite materials: engineering and science. London; New York, Chapman & Hall.
|
Matthews, F. L. and R. D. Rawlings (1999). Composite materials: engineering and science. Cambridge, Woodhead.
|
Matthews, F. L. and R. D. Rawlings (2002). Composite materials: engineering and science. Boca Raton; Cambridge, CRC Press: Woodhead Publishing Ltd.
|
Matthews, F. L., M. International Conference on Composite, et al. (1987). ICCM VI & ECCM 2: Sixth International Conference on Composite Materials: [and] Second European Conference on Composite Materials. London; New York; Warrendale, PA, Elsevier Applied Science: Sole distributor in the USA and Canada the Metallurgical Society.
|
Matthews, F. L., M. International Conference on Composite, et al. (1987). ICCM VI: Sixth International Conference on Composite Materials. & ECCM 2: Second European Conference on Composite Materials. London, Elsevier Applied Science.
|
Matthews, F. L., P. Kalkanis, et al. (1984). The strength of mechanically fastened joints in 'Kevlar' reinforced composite materials. [London], Imperial College of Science and Technology, Dept. of Aeronautics.
|
Matthews, G., I. Llewellyn, et al. (1972). Vinyl chloride and vinyl acetate polymers. London, Iliffe.
|
Matthews, G., P. D. Ritchie, et al. (1972). Vinyl and allied polymers. London, Iliffe for the Plastics Institute.
|
Matthews, J. D. (2004). Geological and physical assessment of the oil reservoir transition zone: 182 leaves.
|
Matti, Y. Y. and T. University of Wales Institute of Science and (1986). The thermal degradation of vinyl chloride polymers and its relation to structure. Cardiff, University of Wales Institute of Science and Technology (UWIST).
|
Mattoso Luiz Henrique, C. and F. A. O. E. C. R. N. o. F. a. O. B. P. W. G. WG, Eds. (2000). Natural polymers and composites.
|
Mattoso Luiz, H. C., A. Leao, et al., Eds. (1998). Proceedings of the "second international symposium on natural polymers and composites", Embrapa Agricultural Instrumentation.
|
Matyjaszewski, K. and T. P. Davis (2002). Handbook of radical polymerization. Hoboken, Wiley-Interscience.
|
